Modern finishing systems your team can actually run.

Wrap the part. Waste less paint.

Electrostatic guns charge the paint so it's drawn to the grounded part and wraps around edges and tubing — putting more coating on the part and less in your filters. Modern guns are lighter, digitally controlled and far more forgiving than the systems many plants still nurse along. We help you replace the old setup without stopping production.

• An aging electrostatic system only one veteran painter can keep running
• Heavy, tiring guns and inconsistent film build across a shift
• High paint use, fast-loading booth filters and too much overspray
• Poor coverage on edges, tubing, racks and wire goods

The right booth for your parts, your building and your code.

A booth is more than a box with fans. Airflow, filtration, make-up air, lighting, fire protection, electrical and permitting all have to work together — and installed cost is often double the booth price. We design around your parts and your floor, coordinate the details, and install systems that pass inspection and run efficiently through an Ohio winter.

• Dirt in the finish and overspray drifting back onto parts
• Booth pressure problems, slow filter-loading alarms or no manometer at all
• Parts outgrowing the booth, or the booth limiting throughput
• Fire marshal, insurer or EPA questions about your spray area

The right gun beats the most expensive gun.

Conventional, HVLP, LVLP, airless and air-assisted airless guns each have a job they do best. We match the applicator to your coating, part and finish spec — then supply the tips, needles, caps and rebuild kits to keep it spraying like new.

• Orange peel, dry spray, runs or sags you can't tune out
• High paint use and overspray with your current guns
• Guns that aren't a compliant type under EPA 6H or 6X
• Painters fighting heavy or worn-out equipment

Powder that sticks — because the whole system was planned.

Successful powder coating is a system: pretreatment, guns, booth, recovery and cure oven sized to your parts and color changes. Most powder failures are pretreatment failures, so we look at the whole line — whether you're adding a first batch system or upgrading guns on an existing one.

• Poor adhesion or film failures on powder-coated parts
• Thin coverage in corners and recesses (Faraday cage areas)
• Slow color changes or too much powder wasted
• Considering a switch from liquid paint to powder

The parts you need, before the line goes down.

Booth filters, gun parts, tips, hose, fittings, cups, solvent recyclers, PPE — the everyday items that keep a finishing operation running and compliant. Send us your list or part numbers and we'll quote it fast. We can also set up recurring orders so filters and spares arrive before you run out.

• Running out of booth filters or critical spares at the worst moment
• Not sure your exhaust filters meet EPA's 98% capture requirement
• Part numbers scattered across old boxes, manuals and email
• Paying for expedited freight because nobody reordered in time