Peeling, orange peel, runs, dirt, color variation, slow cure — you know what's wrong with the finish, but not why. Our technical sales specialists come to the plant, watch the process from mix room to cure, and trace the problem to its source before recommending anything. Sometimes the fix is a setting. Sometimes it's equipment. Either way, you'll know.
If you're seeing any of these, we can help — usually starting with a conversation and a visit to your floor.
- Peeling, flaking or adhesion failures
- Orange peel, runs, sags or dry spray
- Dirt, fisheyes or contamination in the finish
- Color or gloss variation between parts, shifts or booths
- Slow cure, soft film or rework you can't explain
Diagnose first. Recommend second. Then make sure your team can run it.
Tell us what you see
Photos, part info and when it started. Upload them with your request.
We come to the floor
We observe the process end to end: prep, mixing, delivery, application, booth and cure.
Find the root cause
Ratio checks, pressures, airflow, settings and technique — measured, not guessed.
Fix what's actually wrong
A written recommendation, from simple adjustments to equipment changes, sized to the problem.
Typical starting points — every recommendation is fit to your parts, coatings, volumes and people.
Option 1
Adjust
Best for: Settings, technique or maintenance
- On-site observation
- Setting and setup corrections
- Operator coaching
Option 2
Repair
Best for: Worn or failing components
- Rebuild kits and replacement parts
- Filter and airflow corrections
- Preventive maintenance plan
Option 3
Upgrade
Best for: Equipment no longer fits the job
- Right-sized system recommendation
- Vendor-partnered design
- Install and training
We're brand-flexible: we'll recommend what fits your job, not what fills a quota.
Questions we hear
Is there a charge for a site visit?
Tell us about the problem in your request and we'll confirm scope before we come out.
What should we have ready?
Photos of the defect, coating technical data sheets, your equipment makes and models, and access to watch a normal production run.
Send a parts list or describe the problem. A finishing specialist will respond within one business day with next steps, pricing and timeline.